top of page

PH9C

Specifications

Aluminum housing

3 electronically balanced inputs with RF filter on male XLR connectors

2 Male XLR connectors for parallel outputs with Left and Right program inputs.

1 Male XLR connector for AUX input.

1 ¼ Jack connector in parallel with the AUX input.

PIN 1 LIFT switch on all inputs.

Internal universal power supply 40 watts 90-240 volts 50/60 hertz

110-240 volt input module with fuse.

Carrying handles.

Support for installation on microphone stand (Flange)

Headphone connectors: 2 ¼ jack and 2 1/8 jack

Volume and balance control

Stereo 10 LED VU indicator

CSA compliant

2 years warranty

Input Impedance:                        24k ohms

Maximum input level                 +24 dBm

Output impedance:                    1.0 ohm (headphone)

It accepts headphones with an impedance of up to 8 ohms

 

Maximum output level:              +18dbu

Noise:                                            -84.8 dbu (ref: See test report)

Gain Control:                               -60 to +15 dBm

THD +N:                                        .004% at 1K Hz

AC consumption 1.25 Amp 110 volts

Stereo Parity:                              .4 dBm from 9 o'clock position to full CW

CMRR of Inputs: Typical DC:     90 dB, 60 Hz: 90 dB, 20 K Hz: 85 dB

weight:                                         2.2 lb / 1kg

Dimensions:                                7.3” x 4.7” x 3.07”

Available inventory: 13

bottom of page